> 新闻中心
The wind form into the FBN counterflow cooling tower for the bottomreflux into the wind, and spraying water falling reverse alternately formed saturated hot air, heat is discharged from the top fan, waterby dewatering device with special structure is turned back into thewater cycle use, internal space no pre - cooling fillers, Yu more space to increase unit heat transfer area, the coil of compact structure, small occupation of land. Fluid cooling is especially suitable for low temperature or temperature difference.
Structural components:
A, fan: using three wind machine indoor and outdoor environment,corrosion protection grade reaches IP55, insulation class up to F, to ensure that the service life. Low noise, high transmission efficiency,water does not slip. The wind induced wind type, according to the aerodynamic basis, full use of the gas flow field theory, reduces theeddy current region, effectively reduces the wind resistance, so that the kinetic energy loss in air decreased by 34%, the maximumincrease the air blower and the fan working efficiency, reduce theair recirculation, lowering the work noise.
D, the heat dissipating layer: PVC material used, lower temperature,to prevent the coil deconstruction. Spray water cycle low, better heat transfer efficiency, is conducive to saving energy.
C, tank: tilt design, stainless steel screen, manual or electroniclevel, set up a special overflow port and the sewage outfall.
D, spray jump, circulating pump: the overall type centrifugal pumpmechanical seal, all with the waterproof motor, import bearings, low head, high flow, low power.
E, spray water distribution system: a model of orchid flower typenozzle injection molding ABS and PP materials with high strength,long service life, water is fine, uniform water spraying, water distribution area, good cooling effect, effectively reduce the loss ofspray pump.
F, Feng Shui: due to spray water and air to flow through the coil,the spray will maximum coverage in the coil surface, ensure the coilsurface wetting. Compared with the Feng Shui reverse mechanism,reducing the formation of pipe wall dry and scaling.
G, maintenance and space in the tower: into the tower throughmaintenance, enough space to provide the convenience formaintenance, the key parts - coil repair because of reasonablestructure and easy a lot of equipment.
Notable characteristics:
1 composite flow cooling tower inlet, exhaust and spraying water toform for the same flow, so that the spray water to the outer wall of the pipe completely wrapped and moist. Avoid like upstreamproducts as easy to do in the following form, avoid because of high water temperature in some parts of scale. The main reason of coil.Scaling is to spray the water temperature is too high, equipment in the PVC heat sink layer arrangement for reducing the water temperature, low temperature makes it easy to form scale after thecalcium ion, magnesium ion, not easily attached on the pipe, to avoid the accumulation of dirt. In the thermal compound flow cooling tower is sensible and latent heat through heat pipe wetted surface of the pipe wall to heat, heat exchange mode that helps preventfouling.
